diff mbox series

[RFC,v1,1/5] mgmt-api: Add Send HCI command and wait for event Command

Message ID 20241023204705.2422998-1-luiz.dentz@gmail.com
State New
Headers show
Series [RFC,v1,1/5] mgmt-api: Add Send HCI command and wait for event Command | expand

Commit Message

Luiz Augusto von Dentz Oct. 23, 2024, 8:47 p.m. UTC 
From: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>

This adds Send HCI command and wait for event Command initial
documentation.
---
 doc/mgmt-api.txt | 30 ++++++++++++++++++++++++++++++
 1 file changed, 30 insertions(+)
diff mbox series

Patch

diff --git a/doc/mgmt-api.txt b/doc/mgmt-api.txt
index 59e61d361dc2..d37eae402861 100644
--- a/doc/mgmt-api.txt
+++ b/doc/mgmt-api.txt
@@ -3991,6 +3991,36 @@  Cancel Transmit Mesh Packet Command
 	Possible errors:	Failed
 				Invalid Parameters
 
+Send HCI command and wait for event Command
+===========================================
+
+	Command Code:		0x005B
+	Controller Index:	<controller id>
+	Command Parameters:	Opcode (2 Octets)
+				Event (1 Octet)
+				Timeout (1 Octet)
+				Parameter Length (2 Octets)
+				Parameter (variable)
+	Return Parameters:	Response (1-variable Octets)
+
+	This command may be used to send a HCI command and wait for an
+	(optional) event.
+
+	The HCI command is specified by the Opcode, any arbitrary is supported
+	including vendor commands, but contrary to the like of
+	Raw/User channel it is run as an HCI command send by the kernel
+	since it uses its command synchronization thus it is possible to wait
+	for a specific event as a response.
+
+	Setting event to 0x00 will cause the command to wait for either
+	HCI Command Status or HCI Command Complete.
+
+	Timeout is specified in seconds, setting it to 0 will cause the
+	default timeout to be used.
+
+	Possible errors:	Failed
+				Invalid Parameters
+
 Command Complete Event
 ======================