@@ -5339,6 +5339,10 @@ static int hci_connect_cancel_sync(struct hci_dev *hdev, struct hci_conn *conn,
if (test_bit(HCI_CONN_CREATE_CIS, &conn->flags))
return hci_disconnect_sync(hdev, conn, reason);
+ /* CIS with no Create CIS sent have nothing to cancel */
+ if (bacmp(&conn->dst, BDADDR_ANY))
+ return HCI_ERROR_LOCAL_HOST_TERM;
+
/* There is no way to cancel a BIS without terminating the BIG
* which is done later on connection cleanup.
*/
@@ -5426,9 +5430,17 @@ int hci_abort_conn_sync(struct hci_dev *hdev, struct hci_conn *conn, u8 reason)
case BT_CONNECT2:
return hci_reject_conn_sync(hdev, conn, reason);
case BT_OPEN:
- /* Cleanup bises that failed to be established */
- if (test_and_clear_bit(HCI_CONN_BIG_SYNC_FAILED, &conn->flags))
+ /* Cleanup failed CIS, and BIS that failed to be established */
+ if (bacmp(&conn->dst, BDADDR_ANY) ||
+ test_and_clear_bit(HCI_CONN_BIG_SYNC_FAILED, &conn->flags))
+ hci_conn_failed(conn, reason);
+ break;
+ case BT_BOUND:
+ /* Bound CIS should be cleaned up */
+ if (conn->type == ISO_LINK && bacmp(&conn->dst, BDADDR_ANY))
hci_conn_failed(conn, reason);
+ else
+ conn->state = BT_CLOSED;
break;
default:
conn->state = BT_CLOSED;
Dropped CIS that are in state BT_OPEN/BT_BOUND, and in state BT_CONNECT with HCI_CONN_CREATE_CIS unset, should be cleaned up immediately. Closing CIS ISO sockets should result to the hci_conn be deleted, so that potentially pending CIG removal can run. hci_abort_conn cannot refer to them by handle, since their handle is still unset if Set CIG Parameters has not yet completed. This fixes CIS not being terminated if the socket is shut down immediately after connection, so that the hci_abort_conn runs before Set CIG Parameters completes. See new BlueZ test "ISO Connect Close - Success" Signed-off-by: Pauli Virtanen <pav@iki.fi> --- net/bluetooth/hci_sync.c | 16 ++++++++++++++-- 1 file changed, 14 insertions(+), 2 deletions(-)