@@ -55,6 +55,16 @@ config NVMEM_IMX_OCOTP_SCU
This is a driver for the SCU On-Chip OTP Controller (OCOTP)
available on i.MX8 SoCs.
+config JZ4780_EFUSE
+ tristate "JZ4780 EFUSE Memory Support"
+ depends on MACH_INGENIC || COMPILE_TEST
+ depends on HAS_IOMEM
+ help
+ Say Y here to include support for JZ4780 efuse memory found on
+ all JZ4780 SoC based devices.
+ To compile this driver as a module, choose M here: the module
+ will be called nvmem_jz4780_efuse.
+
config NVMEM_LPC18XX_EEPROM
tristate "NXP LPC18XX EEPROM Memory Support"
depends on ARCH_LPC18XX || COMPILE_TEST
@@ -18,6 +18,8 @@ obj-$(CONFIG_NVMEM_IMX_OCOTP) += nvmem-imx-ocotp.o
nvmem-imx-ocotp-y := imx-ocotp.o
obj-$(CONFIG_NVMEM_IMX_OCOTP_SCU) += nvmem-imx-ocotp-scu.o
nvmem-imx-ocotp-scu-y := imx-ocotp-scu.o
+obj-$(CONFIG_JZ4780_EFUSE) += nvmem_jz4780_efuse.o
+nvmem_jz4780_efuse-y := jz4780-efuse.o
obj-$(CONFIG_NVMEM_LPC18XX_EEPROM) += nvmem_lpc18xx_eeprom.o
nvmem_lpc18xx_eeprom-y := lpc18xx_eeprom.o
obj-$(CONFIG_NVMEM_LPC18XX_OTP) += nvmem_lpc18xx_otp.o
new file mode 100644
@@ -0,0 +1,229 @@
+// SPDX-License-Identifier: GPL-2.0-or-later
+/*
+ * JZ4780 EFUSE Memory Support driver
+ *
+ * Copyright (c) 2017 PrasannaKumar Muralidharan <prasannatsmkumar@gmail.com>
+ * Copyright (c) 2020 H. Nikolaus Schaller <hns@goldelico.com>
+ */
+
+/*
+ * Currently supports JZ4780 efuse which has 8K programmable bit.
+ * Efuse is separated into seven segments as below:
+ *
+ * -----------------------------------------------------------------------
+ * | 64 bit | 128 bit | 128 bit | 3520 bit | 8 bit | 2296 bit | 2048 bit |
+ * -----------------------------------------------------------------------
+ *
+ * The rom itself is accessed using a 9 bit address line and an 8 word wide bus
+ * which reads/writes based on strobes. The strobe is configured in the config
+ * register and is based on number of cycles of the bus clock.
+ *
+ * Driver supports read only as the writes are done in the Factory.
+ */
+
+#include <linux/bitops.h>
+#include <linux/clk.h>
+#include <linux/module.h>
+#include <linux/nvmem-provider.h>
+#include <linux/of.h>
+#include <linux/platform_device.h>
+#include <linux/regmap.h>
+#include <linux/timer.h>
+
+#define JZ_EFUCTRL (0x0) /* Control Register */
+#define JZ_EFUCFG (0x4) /* Configure Register*/
+#define JZ_EFUSTATE (0x8) /* Status Register */
+#define JZ_EFUDATA(n) (0xC + (n) * 4)
+
+#define EFUCTRL_ADDR_MASK 0x3FF
+#define EFUCTRL_ADDR_SHIFT 21
+#define EFUCTRL_LEN_MASK 0x1F
+#define EFUCTRL_LEN_SHIFT 16
+#define EFUCTRL_PG_EN BIT(15)
+#define EFUCTRL_WR_EN BIT(1)
+#define EFUCTRL_RD_EN BIT(0)
+
+#define EFUCFG_INT_EN BIT(31)
+#define EFUCFG_RD_ADJ_MASK 0xF
+#define EFUCFG_RD_ADJ_SHIFT 20
+#define EFUCFG_RD_STR_MASK 0xF
+#define EFUCFG_RD_STR_SHIFT 16
+#define EFUCFG_WR_ADJ_MASK 0xF
+#define EFUCFG_WR_ADJ_SHIFT 12
+#define EFUCFG_WR_STR_MASK 0xFFF
+#define EFUCFG_WR_STR_SHIFT 0
+
+#define EFUSTATE_WR_DONE BIT(1)
+#define EFUSTATE_RD_DONE BIT(0)
+
+struct jz4780_efuse {
+ struct device *dev;
+ struct regmap *map;
+ struct clk *clk;
+ unsigned int rd_adj;
+ unsigned int rd_strobe;
+};
+
+/* We read 32 byte chunks to avoid complexity in the driver. */
+static int jz4780_efuse_read_32bytes(struct jz4780_efuse *efuse, char *buf,
+ unsigned int addr)
+{
+ unsigned int tmp;
+ u32 ctrl;
+ int ret;
+ const int size = 32;
+
+ ctrl = (addr << EFUCTRL_ADDR_SHIFT)
+ | ((size - 1) << EFUCTRL_LEN_SHIFT)
+ | EFUCTRL_RD_EN;
+
+ regmap_update_bits(efuse->map, JZ_EFUCTRL,
+ (EFUCTRL_ADDR_MASK << EFUCTRL_ADDR_SHIFT) |
+ (EFUCTRL_LEN_MASK << EFUCTRL_LEN_SHIFT) |
+ EFUCTRL_PG_EN | EFUCTRL_WR_EN | EFUCTRL_RD_EN, ctrl);
+
+ ret = regmap_read_poll_timeout(efuse->map, JZ_EFUSTATE,
+ tmp, tmp & EFUSTATE_RD_DONE,
+ 1 * MSEC_PER_SEC, 50 * MSEC_PER_SEC);
+ if (ret < 0) {
+ dev_err(efuse->dev, "Time out while reading efuse data");
+ return ret;
+ }
+
+ return regmap_bulk_read(efuse->map, JZ_EFUDATA(0),
+ buf, size / sizeof(u32));
+}
+
+/* main entry point */
+static int jz4780_efuse_read(void *context, unsigned int offset,
+ void *val, size_t bytes)
+{
+ struct jz4780_efuse *efuse = context;
+ int ret;
+ const int size = 32;
+
+ while (bytes > 0) {
+ unsigned int start = offset & ~(size - 1);
+ unsigned int chunk = min(bytes, (start + size) - offset);
+
+ if (start == offset && chunk == size) {
+ ret = jz4780_efuse_read_32bytes(efuse, val, start);
+ if (ret < 0)
+ return ret;
+
+ } else {
+ char buf[32];
+
+ ret = jz4780_efuse_read_32bytes(efuse, buf, start);
+ if (ret < 0)
+ return ret;
+
+ memcpy(val, &buf[offset - start], chunk);
+ }
+
+ val += chunk;
+ offset += chunk;
+ bytes -= chunk;
+ }
+
+ return 0;
+}
+
+static struct nvmem_config jz4780_efuse_nvmem_config __initdata = {
+ .name = "jz4780-efuse",
+ .size = 1024,
+ .word_size = 1,
+ .stride = 1,
+ .owner = THIS_MODULE,
+ .reg_read = jz4780_efuse_read,
+};
+
+static const struct regmap_config jz4780_efuse_regmap_config = {
+ .reg_bits = 32,
+ .val_bits = 32,
+ .reg_stride = 4,
+ .max_register = JZ_EFUDATA(7),
+};
+
+static int jz4780_efuse_probe(struct platform_device *pdev)
+{
+ struct nvmem_device *nvmem;
+ struct jz4780_efuse *efuse;
+ struct nvmem_config cfg;
+ unsigned long clk_rate;
+ struct device *dev = &pdev->dev;
+ void __iomem *regs;
+
+ efuse = devm_kzalloc(dev, sizeof(*efuse), GFP_KERNEL);
+ if (!efuse)
+ return -ENOMEM;
+
+ regs = devm_platform_ioremap_resource(pdev, 0);
+ if (IS_ERR(regs))
+ return PTR_ERR(regs);
+
+ efuse->map = devm_regmap_init_mmio(dev, regs,
+ &jz4780_efuse_regmap_config);
+ if (IS_ERR(efuse->map))
+ return PTR_ERR(efuse->map);
+
+ efuse->clk = devm_clk_get(&pdev->dev, NULL);
+ if (IS_ERR(efuse->clk))
+ return PTR_ERR(efuse->clk);
+
+ clk_rate = clk_get_rate(efuse->clk);
+
+ efuse->dev = dev;
+ /*
+ * rd_adj and rd_strobe are 4 bit values
+ * bus clk period * (rd_adj + 1) > 6.5ns
+ * bus clk period * (rd_adj + 5 + rd_strobe) > 35ns
+ */
+ efuse->rd_adj = (((6500 * (clk_rate / 1000000)) / 1000000) + 1) - 1;
+ efuse->rd_strobe = ((((35000 * (clk_rate / 1000000)) / 1000000) + 1)
+ - 5 - efuse->rd_adj);
+
+ if (efuse->rd_adj > 0x1F || efuse->rd_strobe > 0x1F) {
+ dev_err(&pdev->dev, "Cannot set clock configuration\n");
+ return -EINVAL;
+ }
+
+ regmap_update_bits(efuse->map, JZ_EFUCFG,
+ (EFUCFG_RD_ADJ_MASK << EFUCFG_RD_ADJ_SHIFT) |
+ (EFUCFG_RD_STR_MASK << EFUCFG_RD_STR_SHIFT),
+ (efuse->rd_adj << EFUCFG_RD_ADJ_SHIFT) |
+ (efuse->rd_strobe << EFUCFG_RD_STR_SHIFT));
+
+ cfg = jz4780_efuse_nvmem_config;
+ cfg.dev = &pdev->dev;
+ cfg.priv = efuse;
+
+ nvmem = devm_nvmem_register(dev, &cfg);
+ if (IS_ERR(nvmem))
+ return PTR_ERR(nvmem);
+
+ platform_set_drvdata(pdev, nvmem);
+
+ return 0;
+}
+
+static const struct of_device_id jz4780_efuse_match[] = {
+ { .compatible = "ingenic,jz4780-efuse" },
+ { /* sentinel */ },
+};
+MODULE_DEVICE_TABLE(of, jz4780_efuse_match);
+
+static struct platform_driver jz4780_efuse_driver = {
+ .probe = jz4780_efuse_probe,
+ .driver = {
+ .name = "jz4780-efuse",
+ .of_match_table = jz4780_efuse_match,
+ },
+};
+module_platform_driver(jz4780_efuse_driver);
+
+MODULE_AUTHOR("PrasannaKumar Muralidharan <prasannatsmkumar@gmail.com>");
+MODULE_AUTHOR("H. Nikolaus Schaller <hns@goldelico.com>");
+MODULE_AUTHOR("Paul Cercueil <paul@crapouillou.net>");
+MODULE_DESCRIPTION("Ingenic JZ4780 efuse driver");
+MODULE_LICENSE("GPL v2");