@@ -62,6 +62,7 @@ $defs:
Pinctrl node's client devices use subnodes for desired pin configuration.
Client device subnodes use below standard properties.
$ref: qcom,tlmm-common.yaml#/$defs/qcom-tlmm-state
+ unevaluatedProperties: false
properties:
pins:
@@ -110,20 +111,9 @@ $defs:
uim1_clk, uim1_data, uim1_present, uim1_reset, usb2phy_ac,
usb_phy, vfr_0, vfr_1, vsense_trigger ]
- bias-pull-down: true
- bias-pull-up: true
- bias-bus-hold: true
- bias-disable: true
- drive-strength: true
- input-enable: true
- output-high: true
- output-low: true
-
required:
- pins
- additionalProperties: false
-
allOf:
- $ref: /schemas/pinctrl/qcom,tlmm-common.yaml#
All Qualcomm SoC Top Level Mode Multiplexer pin controllers have similar capabilities regarding pin properties, thus we can just accept entire set provided by qcom,tlmm-common.yaml schema. This also fixes warnings like: sc7280-herobrine-evoker.dtb: pinctrl@f100000: qspi-sleep-state: 'oneOf' conditional failed, one must be fixed: 'output-disable' does not match any of the regexes: 'pinctrl-[0-9]+' Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> --- .../bindings/pinctrl/qcom,sc7280-pinctrl.yaml | 12 +----------- 1 file changed, 1 insertion(+), 11 deletions(-)