diff mbox series

[RFC,v2,4/5] gpio: add pinctrl based generic gpio driver

Message ID 20231005025843.508689-5-takahiro.akashi@linaro.org
State New
Headers show
Series gpio: add pinctrl based generic gpio driver | expand

Commit Message

AKASHI Takahiro Oct. 5, 2023, 2:58 a.m. UTC
Some pin controllers provide not only a method to set up lines but
also gpio function. With this commit, a new generic gpio driver will
be provided. It is implemented purely by using pinctrl interfaces.
One of such pin controllers is Arm's SCMI.

Signed-off-by: AKASHI Takahiro <takahiro.akashi@linaro.org>
---
RFC v2 (Oct 5, 2023)
* rename the driver to pin-control-gpio (CONFIG_GPIO_BY_PINCTRL)
* return meaningful error codes instead of -1
* remove the masking at PIN_CONFIG_PACKED
* handle emulated OPEN_DRAIN configuration at get_direction()
* define config_set in gpio_chip
* drop remove hook
RFC (Oct 2, 2023)
---
 drivers/gpio/Kconfig           |   7 ++
 drivers/gpio/Makefile          |   1 +
 drivers/gpio/gpio-by-pinctrl.c | 165 +++++++++++++++++++++++++++++++++
 3 files changed, 173 insertions(+)
 create mode 100644 drivers/gpio/gpio-by-pinctrl.c

Comments

Linus Walleij Oct. 10, 2023, noon UTC | #1
On Thu, Oct 5, 2023 at 4:59 AM AKASHI Takahiro
<takahiro.akashi@linaro.org> wrote:


> Some pin controllers provide not only a method to set up lines but
> also gpio function. With this commit, a new generic gpio driver will
> be provided. It is implemented purely by using pinctrl interfaces.
> One of such pin controllers is Arm's SCMI.
>
> Signed-off-by: AKASHI Takahiro <takahiro.akashi@linaro.org>
> ---
> RFC v2 (Oct 5, 2023)

RFC v2 looks very good to me, definitely something that can be merged
as a starting point once the hardware has been tested.

> +static int pin_control_gpio_direction_input(struct gpio_chip *chip,
> +                                           unsigned int offset)
> +{
> +       return pinctrl_gpio_direction_input(chip->gpiodev->base + offset);
> +}
> +
> +static int pin_control_gpio_direction_output(struct gpio_chip *chip,
> +                                            unsigned int offset, int val)
> +{
> +       return pinctrl_gpio_direction_output(chip->gpiodev->base + offset);
> +}

IIRC Bartosz is working on a patch set getting rid of this kludge having to
call with base + offset in every driver, replacing it with generic calls that
you can just assign in the gpio_chip.

When this gets applied these changes will likely be in place so you will
get rid of this too.

Yours,
Linus Walleij
diff mbox series

Patch

diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index 673bafb8be58..a60972be114c 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -216,6 +216,13 @@  config GPIO_BRCMSTB
 	help
 	  Say yes here to enable GPIO support for Broadcom STB (BCM7XXX) SoCs.
 
+config GPIO_BY_PINCTRL
+	tristate "GPIO support based on a pure pin control backend"
+	depends on GPIOLIB
+	help
+	  Select this option to support GPIO devices based solely on pin
+	  control, specifically pin configuration, such as SCMI.
+
 config GPIO_CADENCE
 	tristate "Cadence GPIO support"
 	depends on OF_GPIO
diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile
index eb73b5d633eb..71458d81e16a 100644
--- a/drivers/gpio/Makefile
+++ b/drivers/gpio/Makefile
@@ -43,6 +43,7 @@  obj-$(CONFIG_GPIO_BD71828)		+= gpio-bd71828.o
 obj-$(CONFIG_GPIO_BD9571MWV)		+= gpio-bd9571mwv.o
 obj-$(CONFIG_GPIO_BRCMSTB)		+= gpio-brcmstb.o
 obj-$(CONFIG_GPIO_BT8XX)		+= gpio-bt8xx.o
+obj-$(CONFIG_GPIO_BY_PINCTRL)		+= gpio-by-pinctrl.o
 obj-$(CONFIG_GPIO_CADENCE)		+= gpio-cadence.o
 obj-$(CONFIG_GPIO_CLPS711X)		+= gpio-clps711x.o
 obj-$(CONFIG_GPIO_SNPS_CREG)		+= gpio-creg-snps.o
diff --git a/drivers/gpio/gpio-by-pinctrl.c b/drivers/gpio/gpio-by-pinctrl.c
new file mode 100644
index 000000000000..c297a9633e03
--- /dev/null
+++ b/drivers/gpio/gpio-by-pinctrl.c
@@ -0,0 +1,165 @@ 
+// SPDX-License-Identifier: GPL-2.0
+//
+// Copyright (C) 2023 Linaro Inc.
+//   Author: AKASHI takahiro <takahiro.akashi@linaro.org>
+
+#include <linux/gpio/driver.h>
+#include <linux/list.h>
+#include <linux/module.h>
+#include <linux/pinctrl/consumer.h>
+#include <linux/platform_device.h>
+#include <linux/types.h>
+#include "gpiolib.h"
+
+struct pin_control_gpio_priv {
+	struct gpio_chip chip;
+};
+
+static int pin_control_gpio_get_direction(struct gpio_chip *chip,
+				      unsigned int offset)
+{
+	unsigned long config;
+	bool out_en, in_en;
+	int ret;
+
+	config = PIN_CONFIG_OUTPUT_ENABLE;
+	ret = pinctrl_gpio_get_config(chip->gpiodev->base + offset, &config);
+	if (!ret)
+		out_en = !!config;
+	else if (ret == -EINVAL)
+		out_en = false;
+	else
+		return ret;
+
+	config = PIN_CONFIG_INPUT_ENABLE;
+	ret = pinctrl_gpio_get_config(chip->gpiodev->base + offset, &config);
+	if (!ret)
+		in_en = !!config;
+	else if (ret == -EINVAL)
+		in_en = false;
+	else
+		return ret;
+
+	if (in_en && !out_en)
+		return GPIO_LINE_DIRECTION_IN;
+
+	if (!in_en && out_en)
+		return GPIO_LINE_DIRECTION_OUT;
+
+	if (in_en && out_en) {
+	    /* This may be an emulation for output with open drain */
+		config = PIN_CONFIG_DRIVE_OPEN_DRAIN;
+		ret = pinctrl_gpio_get_config(chip->gpiodev->base + offset,
+					      &config);
+		if (!ret && config)
+			return GPIO_LINE_DIRECTION_OUT;
+	}
+
+	return -EINVAL;
+}
+
+static int pin_control_gpio_direction_input(struct gpio_chip *chip,
+					    unsigned int offset)
+{
+	return pinctrl_gpio_direction_input(chip->gpiodev->base + offset);
+}
+
+static int pin_control_gpio_direction_output(struct gpio_chip *chip,
+					     unsigned int offset, int val)
+{
+	return pinctrl_gpio_direction_output(chip->gpiodev->base + offset);
+}
+
+static int pin_control_gpio_get(struct gpio_chip *chip, unsigned int offset)
+{
+	unsigned long config;
+	int ret;
+
+	config = PIN_CONFIG_INPUT;
+	ret = pinctrl_gpio_get_config(chip->gpiodev->base + offset, &config);
+	if (ret)
+		return ret;
+
+	if (config >> 8)
+		return 1;
+
+	return 0;
+}
+
+static void pin_control_gpio_set(struct gpio_chip *chip, unsigned int offset,
+				 int val)
+{
+	unsigned long config;
+
+	config = PIN_CONF_PACKED(PIN_CONFIG_OUTPUT, val);
+
+	pinctrl_gpio_set_config(chip->gpiodev->base + offset, config);
+}
+
+static u16 sum_up_ngpios(struct gpio_chip *chip)
+{
+	struct gpio_pin_range *range;
+	struct gpio_device *gdev = chip->gpiodev;
+	u16 ngpios = 0;
+
+	list_for_each_entry(range, &gdev->pin_ranges, node) {
+		ngpios += range->range.npins;
+	}
+
+	return ngpios;
+}
+
+static int pin_control_gpio_probe(struct platform_device *pdev)
+{
+	struct device *dev = &pdev->dev;
+	struct pin_control_gpio_priv *priv;
+	struct gpio_chip *chip;
+	int ret;
+
+	priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
+	if (!priv)
+		return -ENOMEM;
+
+	chip = &priv->chip;
+	chip->label = dev_name(dev);
+	chip->parent = dev;
+	chip->base = -1;
+
+	chip->request = gpiochip_generic_request;
+	chip->free = gpiochip_generic_free;
+	chip->get_direction = pin_control_gpio_get_direction;
+	chip->direction_input = pin_control_gpio_direction_input;
+	chip->direction_output = pin_control_gpio_direction_output;
+	chip->get = pin_control_gpio_get;
+	chip->set = pin_control_gpio_set;
+	chip->set_config = gpiochip_generic_config;
+
+	ret = devm_gpiochip_add_data(dev, chip, priv);
+	if (ret)
+		return ret;
+
+	chip->ngpio = sum_up_ngpios(chip);
+
+	platform_set_drvdata(pdev, priv);
+
+	return 0;
+}
+
+static const struct of_device_id pin_control_gpio_match[] = {
+	{ .compatible = "pin-control-gpio" },
+	{ /* sentinel */ }
+};
+MODULE_DEVICE_TABLE(of, pin_control_gpio_match);
+
+static struct platform_driver pin_control_gpio_driver = {
+	.probe = pin_control_gpio_probe,
+	.driver = {
+		.name = "pin-control-gpio",
+		.of_match_table = pin_control_gpio_match,
+	},
+};
+module_platform_driver(pin_control_gpio_driver);
+
+MODULE_AUTHOR("AKASHI Takahiro <takahiro.akashi@linaro.org>");
+MODULE_DESCRIPTION("Pinctrl based GPIO driver");
+MODULE_LICENSE("GPL");