@@ -11,6 +11,7 @@ / {
compatible = "geniatech,xpi-3128", "rockchip,rk3128";
aliases {
+ ethernet0 = &gmac;
gpio0 = &gpio0;
gpio1 = &gpio1;
gpio2 = &gpio2;
@@ -255,6 +256,18 @@ &emmc {
status = "okay";
};
+&gmac {
+ clock_in_out = "output";
+ phy-supply = <&vcc_lan>;
+ phy-mode = "rmii";
+ phy-handle = <&phy0>;
+ assigned-clocks = <&cru SCLK_MAC_SRC>;
+ assigned-clock-rates= <50000000>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&rmii_pins>;
+ status = "okay";
+};
+
&gpio0 {
gpio-line-names = /* GPIO0 A0-A7 */
"", "", "HEADER_5", "HEADER_3",
@@ -315,6 +328,21 @@ &gpio3 {
"", "", "", "";
};
+&mdio {
+ phy0: ethernet-phy@1 {
+ compatible = "ethernet-phy-ieee802.3-c22";
+ reg = <1>;
+ max-speed = <100>;
+ /* T2.2.4 min. 1 us */
+ reset-assert-us = <10>;
+ /* T2.2.1 + T2.2.2 + T2.2.3 min. 6.05 us */
+ reset-deassert-us = <20>;
+ reset-gpios = <&gpio2 RK_PD0 GPIO_ACTIVE_LOW>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&dp83848c_rst>;
+ };
+};
+
&pinctrl {
dp83848c {
dp83848c_rst: dp83848c-rst {
Add the required properties and enable the gmac node for XPI-3128 board. The minimum reset timing requirements for the phy have been taken from DP83848J's datasheet [0] [0] https://www.ti.com/lit/ds/symlink/dp83848j.pdf Signed-off-by: Alex Bee <knaerzche@gmail.com> --- .../arm/boot/dts/rockchip/rk3128-xpi-3128.dts | 28 +++++++++++++++++++ 1 file changed, 28 insertions(+)