diff mbox series

[v2,2/5] powerpc: 83xx/gpio: use new line value setter callbacks

Message ID 20250502-gpiochip-set-rv-powerpc-v2-2-488e43e325bf@linaro.org
State New
Headers show
Series powerpc: convert board-file GPIO chips to using new value setters | expand

Commit Message

Bartosz Golaszewski May 2, 2025, 8:59 a.m. UTC 
From: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

struct gpio_chip now has callbacks for setting line values that return
an integer, allowing to indicate failures. Convert the driver to using
them.

Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
---
 arch/powerpc/platforms/83xx/mcu_mpc8349emitx.c | 13 ++++++++-----
 1 file changed, 8 insertions(+), 5 deletions(-)
diff mbox series

Patch

diff --git a/arch/powerpc/platforms/83xx/mcu_mpc8349emitx.c b/arch/powerpc/platforms/83xx/mcu_mpc8349emitx.c
index 4d8fa9ed1a678..6e37dfc6c5c9e 100644
--- a/arch/powerpc/platforms/83xx/mcu_mpc8349emitx.c
+++ b/arch/powerpc/platforms/83xx/mcu_mpc8349emitx.c
@@ -92,10 +92,11 @@  static void mcu_power_off(void)
 	mutex_unlock(&mcu->lock);
 }
 
-static void mcu_gpio_set(struct gpio_chip *gc, unsigned int gpio, int val)
+static int mcu_gpio_set(struct gpio_chip *gc, unsigned int gpio, int val)
 {
 	struct mcu *mcu = gpiochip_get_data(gc);
 	u8 bit = 1 << (4 + gpio);
+	int ret;
 
 	mutex_lock(&mcu->lock);
 	if (val)
@@ -103,14 +104,16 @@  static void mcu_gpio_set(struct gpio_chip *gc, unsigned int gpio, int val)
 	else
 		mcu->reg_ctrl |= bit;
 
-	i2c_smbus_write_byte_data(mcu->client, MCU_REG_CTRL, mcu->reg_ctrl);
+	ret = i2c_smbus_write_byte_data(mcu->client, MCU_REG_CTRL,
+					mcu->reg_ctrl);
 	mutex_unlock(&mcu->lock);
+
+	return ret;
 }
 
 static int mcu_gpio_dir_out(struct gpio_chip *gc, unsigned int gpio, int val)
 {
-	mcu_gpio_set(gc, gpio, val);
-	return 0;
+	return mcu_gpio_set(gc, gpio, val);
 }
 
 static int mcu_gpiochip_add(struct mcu *mcu)
@@ -123,7 +126,7 @@  static int mcu_gpiochip_add(struct mcu *mcu)
 	gc->can_sleep = 1;
 	gc->ngpio = MCU_NUM_GPIO;
 	gc->base = -1;
-	gc->set = mcu_gpio_set;
+	gc->set_rv = mcu_gpio_set;
 	gc->direction_output = mcu_gpio_dir_out;
 	gc->parent = dev;