diff mbox series

[3/4] mmc: mtk-sd: add default PAD control for mt7620

Message ID OSBPR01MB1670E289AE4524B7E192E8ECBC7DA@OSBPR01MB1670.jpnprd01.prod.outlook.com
State New
Headers show
Series mmc: mtk-sd: improve support for mt7620 variant | expand

Commit Message

Shiji Yang June 19, 2025, 5:35 a.m. UTC 
According to the vendor SDK driver, these legacy MIPS MT762x SoCs
require configuring the IO pin drive strength via the PAD control
registers. This should help improve the stability of electrical
signal transmission.

Signed-off-by: Shiji Yang <yangshiji66@outlook.com>
---
 drivers/mmc/host/mtk-sd.c | 8 ++++++++
 1 file changed, 8 insertions(+)
diff mbox series

Patch

diff --git a/drivers/mmc/host/mtk-sd.c b/drivers/mmc/host/mtk-sd.c
index 52198daef..276d4e324 100644
--- a/drivers/mmc/host/mtk-sd.c
+++ b/drivers/mmc/host/mtk-sd.c
@@ -77,6 +77,9 @@ 
 #define MSDC_PATCH_BIT   0xb0
 #define MSDC_PATCH_BIT1  0xb4
 #define MSDC_PATCH_BIT2  0xb8
+#define MSDC_PAD_CTRL0   0xe0
+#define MSDC_PAD_CTRL1   0xe4
+#define MSDC_PAD_CTRL2   0xe8
 #define MSDC_PAD_TUNE    0xec
 #define MSDC_PAD_TUNE0   0xf0
 #define MSDC_DAT_RDDLY0  0xf0
@@ -2038,6 +2041,11 @@  static void msdc_init_hw(struct msdc_host *host)
 	}
 
 	if (host->dev_comp->mips_mt762x) {
+		/* Set default pins drive strength */
+		writel(0x000d0044, host->base + MSDC_PAD_CTRL0);
+		writel(0x000e0044, host->base + MSDC_PAD_CTRL1);
+		writel(0x000e0044, host->base + MSDC_PAD_CTRL2);
+
 		/* Set default tuning parameters */
 		writel(0x84101010, host->base + tune_reg);
 		writel(0x10101010, host->base + MSDC_DAT_RDDLY0);