Show patches with: Submitter = Lee Jones       |    State = Action Required       |    Archived = No       |   334 patches
« 1 2 3 4 »
Patch Series S/W/F Date Submitter Delegate State
[1/9] ARM: integrator: Remove unused icst_params lclk_params structure --- 2012-11-03 Lee Jones New
[2/9] ARM: at91: Remove unused struct at91sam9g45_isi_device and its resources --- 2012-11-03 Lee Jones New
[3/9] x86: Suppress build warnings in quirks --- 2012-11-03 Lee Jones New
[4/9] sched: Don't define unthrottle_offline_cfs_rqs when !CONFIG_SMP --- 2012-11-03 Lee Jones New
[5/9] ASoC: Only compile adav80x codec when a bus is defined --- 2012-11-03 Lee Jones New
[6/9] virtio_mmio: Cast &resources[1].start to ‘unsigned int *’ to rid compiler warning --- 2012-11-03 Lee Jones New
[8/9] isdn: Remove unused variable causing a compile build warning --- 2012-11-03 Lee Jones New
[2/5] Input: bu21013_ts - Move GPIO init and exit functions into the driver --- 2012-11-14 Lee Jones New
[3/5] Input: bu21013_ts - Add support for Device Tree booting --- 2012-11-14 Lee Jones New
[4/5] Input: Enable STMPE keypad driver for Device Tree --- 2012-11-14 Lee Jones New
[5/5] Documentation: Describe bindings for STMPE Keypad driver --- 2012-11-14 Lee Jones New
[03/18] power: ab8500_charger: Detect removed charger --- 2012-12-13 Lee Jones New
[04/18] power: ab8500_fg: flush sync on suspend --- 2012-12-13 Lee Jones New
[05/18] power: ab8500_fg: usleep_range instead of short msleep --- 2012-12-13 Lee Jones New
[07/18] power: ab8500_bm: Recharge condition not optimal for battery --- 2012-12-13 Lee Jones New
[09/18] power: ab8500_btemp: Ignore false btemp low interrupt --- 2012-12-13 Lee Jones New
[13/18] power: ab8500_fg: Added support for BATT_OVV --- 2012-12-13 Lee Jones New
[14/18] power: pm2301: Add pm2301 charger --- 2012-12-13 Lee Jones New
[15/18] power: ab8500_fg: Add sysfs interfaces for capacity --- 2012-12-13 Lee Jones New
[17/18] power: ab8500_charger: Adds support for legacy USB chargers --- 2012-12-13 Lee Jones New
[01/21] gpio: ab8500: Activate and port AB8500 GPIO driver to new framework --- 2012-12-14 Lee Jones New
[02/21] gpio: ab8500: Make pins configurable --- 2012-12-14 Lee Jones New
[03/21] gpio: ab8500: Fix alternate function register address --- 2012-12-14 Lee Jones New
[04/21] gpio: ab8500: Read register corrected in get_value api --- 2012-12-14 Lee Jones New
[05/21] gpio: ab8500: Allow direction and pullups configuration --- 2012-12-14 Lee Jones New
[06/21] gpio: ab8500: Add api to enable pulldown --- 2012-12-14 Lee Jones New
[07/21] gpio: ab8500: Write argument value instead of hardwired 1 --- 2012-12-14 Lee Jones New
[08/21] gpio: ab8500: Fix gpio offset bounds for irq mapping --- 2012-12-14 Lee Jones New
[09/21] gpio: ab8500: Fix bad include name after renaming --- 2012-12-14 Lee Jones New
[10/21] gpio: ab8500: Add support for the AB9540 --- 2012-12-14 Lee Jones New
[11/21] gpio: ab8500: Add support for AB8505 Chip --- 2012-12-14 Lee Jones New
[12/21] gpio: ab8500: Allow gpios to wake the system from suspend --- 2012-12-14 Lee Jones New
[13/21] gpio: ab8500: Use most recent run-time platform checker --- 2012-12-14 Lee Jones New
[14/21] gpio: ab8500: Remove ENUMs from linux/mfd/abx500/ab8500-gpio.h --- 2012-12-14 Lee Jones New
[15/21] gpio: ab8500: Add support for the ab8540 --- 2012-12-14 Lee Jones New
[16/21] gpio: ab8500: Add internal pull up on GPIO of ab8540 --- 2012-12-14 Lee Jones New
[17/21] gpio: ab8500: Add the action range for the internal pull up function on GPIO --- 2012-12-14 Lee Jones New
[18/21] gpio: ab8500: Fix parameter uninitialized warning for ab8540 --- 2012-12-14 Lee Jones New
[19/21] gpio: ab8500: Update gpio ab8540 interrupt mapping --- 2012-12-14 Lee Jones New
[20/21] gpio: ab8500: Fix ab8540 setting direction output error --- 2012-12-14 Lee Jones New
[21/21] gpio: ab8500: Add explicit dependencies --- 2012-12-14 Lee Jones New
[01/73] regulator: ab8500: Remove VBB from suspend force --- 2013-02-04 Lee Jones New
[02/73] regulator: ab8500: Initialize Vrf1 regulator --- 2013-02-04 Lee Jones New
[03/73] regulator: ab8500: Add init values for vsmps1/2 --- 2013-02-04 Lee Jones New
[04/73] regulator: ab8500: Added SysClkReq1 control of Vpll --- 2013-02-04 Lee Jones New
[05/73] ARM: ux500: Vsmps3 controlled by SysClkReq1 --- 2013-02-04 Lee Jones New
[06/73] regulator: ab8500: Add set_mode/get_mode support --- 2013-02-04 Lee Jones New
[07/73] regulator: ab8500: Fix for regulator_set_mode functionality --- 2013-02-04 Lee Jones New
[09/73] ARM: ux500: regulators: Add mask for configuration --- 2013-02-04 Lee Jones New
[10/73] regulator: ab8500: Added more configurable bits --- 2013-02-04 Lee Jones New
[11/73] regulator: ab8500: Removed initialization of body biasing --- 2013-02-04 Lee Jones New
[12/73] regulator: core: Show consumers that hold a regulator in Sysfs --- 2013-02-04 Lee Jones New
[14/73] regulator: ab8500: Add support of low voltage battery --- 2013-02-04 Lee Jones New
[16/73] regulator: ab8500-ext: Cosmetic changes --- 2013-02-04 Lee Jones New
[17/73] regulator: ab8500-ext: Add HW request support --- 2013-02-04 Lee Jones New
[18/73] regulator: ab8500-ext: Add suspend support --- 2013-02-04 Lee Jones New
[19/73] regulator: ab8500-ext: Add regulator_set_mode/get_mode --- 2013-02-04 Lee Jones New
[20/73] regulator: ab8500-ext: Add VextSupply1 regulator --- 2013-02-04 Lee Jones New
[21/73] regulator: ab8500-ext: Add VextSupply2 regulator --- 2013-02-04 Lee Jones New
[22/73] regulator: ab8500: Remove USB regulator --- 2013-02-04 Lee Jones New
[25/73] ARM: ux500: Add supply for the Proximity and Hal sensor --- 2013-02-04 Lee Jones New
[30/73] regulator: ab8500: Remove Vsafe voltage settings --- 2013-02-04 Lee Jones New
[31/73] regulator: ab8500: Remove Vsafe settings --- 2013-02-04 Lee Jones New
[32/73] regulator: ab8500: Clean out SoC registers --- 2013-02-04 Lee Jones New
[33/73] regulator: ab8500: Add support for the AB9540 --- 2013-02-04 Lee Jones New
[34/73] regulator: ab8500: Correct TVOUT regulator start-up delay --- 2013-02-04 Lee Jones New
[36/73] ARM: ux500: Partially revert changes surrounding audio regulators --- 2013-02-04 Lee Jones New
[37/73] regulator: ab8500: add support for ab8505 --- 2013-02-04 Lee Jones New
[38/73] ARM: ux500: regulator: Use device IDs instead of device names --- 2013-02-04 Lee Jones New
[39/73] regulator: ab8500-ext: Add support for AB9540 regulators --- 2013-02-04 Lee Jones New
[40/73] regulator: ab8500: Add AB8505 register initialization --- 2013-02-04 Lee Jones New
[41/73] regulator: ab8500: Provide full settings for AB8540 regulators --- 2013-02-04 Lee Jones New
[42/73] regulator: ab8500: Correct init mask for AB8540 --- 2013-02-04 Lee Jones New
[43/73] regulator: ab8500: Add VSDIO definition for the AB8540 --- 2013-02-04 Lee Jones New
[44/73] regulator: ab8500: Vaux5/6 cannot be disabled on the AB8540 --- 2013-02-04 Lee Jones New
[45/73] regulator: ab8500: Update voltage handling for fixed voltage regulators --- 2013-02-04 Lee Jones New
[46/73] regulator: ab8500: Delete useless fixed_uV field --- 2013-02-04 Lee Jones New
[47/73] regulator: ab8500: Update AB9540 init masks --- 2013-02-04 Lee Jones New
[48/73] regulator: ab8500: Use regulator_list_voltage_table() --- 2013-02-04 Lee Jones New
[49/73] regulator: ab8500: Fix vsdio parameters for AB8540 based platforms --- 2013-02-04 Lee Jones New
[50/73] regulator: ab8500: Correct regulator id values --- 2013-02-04 Lee Jones New
[51/73] regulator: ab8500: Regulator vaux8 not declared using correct name --- 2013-02-04 Lee Jones New
[52/73] ARM ux500: Remove external regulators from AB8505 init data --- 2013-02-04 Lee Jones New
[54/73] regulator: ab8500: Add voltage selection for AUDIO and ANA on AB8505 --- 2013-02-04 Lee Jones New
[55/73] regulator: ab8500: Provide ExtSupply register init values for AB8505 --- 2013-02-04 Lee Jones New
[56/73] regulator: ab8500: Also check for AB8505 based platforms --- 2013-02-04 Lee Jones New
[57/73] regulator: ab8500: Remove surplus include of id.h --- 2013-02-04 Lee Jones New
[58/73] regulator: ab8500: Add new operations for Vaux3 --- 2013-02-04 Lee Jones New
[59/73] regulator: ab8500: Change mode fix for LDO USB --- 2013-02-04 Lee Jones New
[60/73] ARM: ux500: regulators: Add LDO USB consumer --- 2013-02-04 Lee Jones New
[61/73] regulator: ab8500: Default value on LDO USB to HP --- 2013-02-04 Lee Jones New
[62/73] regulator: ab8500: Remove vusb from AB8540 regulator framework --- 2013-02-04 Lee Jones New
[64/73] regulator: ab8500: Update vdmic, vamic[1|2] parameters for AB8540 --- 2013-02-04 Lee Jones New
[65/73] regulator: ab8500: Update VAna supply management for the AB9540 --- 2013-02-04 Lee Jones New
[66/73] regulator: ab8500-ext: Adapt regulator registration for newly changed API --- 2013-02-04 Lee Jones New
[67/73] regulator: ab8500: Use a struct to select the good regulator configuration --- 2013-02-04 Lee Jones New
[68/73] regulator: ab8500: Provide DT support for additional platforms --- 2013-02-04 Lee Jones New
[69/73] regulator: ab8500: Introduce aux5, aux6 regulators for AB8540 --- 2013-02-04 Lee Jones New
[70/73] regulator: ab8500: Set enable enable_time in regulator_desc --- 2013-02-04 Lee Jones New
[71/73] regulator: ab8500: Remove the need for a 'delay' property --- 2013-02-04 Lee Jones New
« 1 2 3 4 »