Show patches with: Submitter = Lee Jones       |    Archived = No       |   618 patches
« 1 2 ... 4 5 6 7 »
Patch Series S/W/F Date Submitter Delegate State
[26/33] regulator: ab8500: Use a struct to select the good regulator configuration --- 2013-03-28 Lee Jones Accepted
[25/33] regulator: ab8500: Update vdmic, vamic[1|2] parameters for AB8540 --- 2013-03-28 Lee Jones Accepted
[24/33] regulator: ab8500: Add mode operation for v-amic --- 2013-03-28 Lee Jones Accepted
[23/33] regulator: ab8500: Add new operations for Vaux3 --- 2013-03-28 Lee Jones Accepted
[22/33] regulator: ab8500: Also check for AB8505 based platforms --- 2013-03-28 Lee Jones Accepted
[21/33] regulator: ab8500: Add voltage selection for AUDIO and ANA on AB8505 --- 2013-03-28 Lee Jones Accepted
[20/33] regulator: ab8500: Don't register external regulators on AB8505 --- 2013-03-28 Lee Jones Accepted
[19/33] regulator: ab8500: Supply platform specific regulator id values --- 2013-03-28 Lee Jones Accepted
[18/33] regulator: ab8500: Use regulator_list_voltage_table() --- 2013-03-28 Lee Jones Accepted
[17/33] regulator: ab8500: Update voltage handling for fixed voltage regulators --- 2013-03-28 Lee Jones Accepted
[16/33] regulator: ab8500: Add support for the ab8540 --- 2013-03-28 Lee Jones Accepted
[15/33] regulator: ab8500-ext: Add support for AB9540 regulators --- 2013-03-28 Lee Jones New
[14/33] regulator: ab8500: add support for ab8505 --- 2013-03-28 Lee Jones Accepted
[13/33] regulator: ab8500-ext: Add support for AB8505/AB9540 --- 2013-03-28 Lee Jones Accepted
[12/33] regulator: ab8500: Correct TVOUT regulator enable time --- 2013-03-28 Lee Jones Accepted
[11/33] regulator: ab8500: Add support for the ab9540 --- 2013-03-28 Lee Jones Accepted
[10/33] regulator: ab8500: Prepare the driver for additional platforms --- 2013-03-28 Lee Jones Accepted
[09/33] regulator: ab8500: Init debug from regulator driver --- 2013-03-28 Lee Jones Accepted
[08/33] regulator: ab8500: Remove USB regulator --- 2013-03-28 Lee Jones Accepted
[07/33] regulator: ab8500-ext: Add suspend support --- 2013-03-28 Lee Jones New
[06/33] regulator: ab8500-ext: Add HW request support --- 2013-03-28 Lee Jones Accepted
[05/33] ARM: ux500: Setup external regulator supply #2 for HREF v20 boards --- 2013-03-28 Lee Jones Accepted
[04/33] ARM: ux500: Turn off external regulator #1 when early HREFs suspend --- 2013-03-28 Lee Jones Accepted
[03/33] ARM: ux500: Provide a mechanism to over-ride regulator init values --- 2013-03-28 Lee Jones Accepted
[02/33] ARM: ux500: Add regulator platform data for AB8500 external regulators --- 2013-03-28 Lee Jones Accepted
[01/33] regulator: ab8500-ext: New driver to control external regulators --- 2013-03-28 Lee Jones Accepted
[49/49] ARM: ux500: Pass regulator platform data using the new format --- 2013-02-06 Lee Jones New
[48/49] regulator: ab8500: Use regulator_list_voltage_table() to look-up voltages --- 2013-02-06 Lee Jones Superseded
[47/49] regulator: ab8500: Remove the need for a 'delay' property --- 2013-02-06 Lee Jones New
[46/49] regulator: ab8500: Set enable enable_time in regulator_desc --- 2013-02-06 Lee Jones New
[45/49] regulator: ab8500: Introduce aux5, aux6 regulators for AB8540 --- 2013-02-06 Lee Jones New
[44/49] regulator: ab8500: Use a struct to select the good regulator configuration --- 2013-02-06 Lee Jones New
[43/49] regulator: ab8500-ext: Adapt regulator registration for newly changed API --- 2013-02-06 Lee Jones New
[42/49] regulator: ab8500: Update vdmic, vamic[1|2] parameters for AB8540 --- 2013-02-06 Lee Jones New
[41/49] regulator: ab8500: Add mode operation for v-amic --- 2013-02-06 Lee Jones Superseded
[40/49] regulator: ab8500: Default value on LDO USB to HP --- 2013-02-06 Lee Jones New
[39/49] regulator: ab8500: Add new operations for Vaux3 --- 2013-02-06 Lee Jones New
[38/49] regulator: ab8500: Also check for AB8505 based platforms --- 2013-02-06 Lee Jones New
[37/49] regulator: ab8500: Add voltage selection for AUDIO and ANA on AB8505 --- 2013-02-06 Lee Jones New
[36/49] regulator: ab8500: Don't register external regulators on AB8505 --- 2013-02-06 Lee Jones Superseded
[35/49] regulator: ab8500: Correct regulator id values --- 2013-02-06 Lee Jones New
[34/49] regulator: ab8500: Fix vsdio parameters for AB8540 based platforms --- 2013-02-06 Lee Jones New
[33/49] regulator: ab8500: Use regulator_list_voltage_table() --- 2013-02-06 Lee Jones New
[32/49] regulator: ab8500: Delete useless fixed_uV field --- 2013-02-06 Lee Jones New
[31/49] regulator: ab8500: Update voltage handling for fixed voltage regulators --- 2013-02-06 Lee Jones New
[30/49] regulator: ab8500: Add support for the ab8540 --- 2013-02-06 Lee Jones New
[29/49] regulator: ab8500-ext: Add support for AB9540 regulators --- 2013-02-06 Lee Jones New
[28/49] ARM: ux500: regulator: Use device IDs instead of device names --- 2013-02-06 Lee Jones New
[27/49] regulator: ab8500: add support for ab8505 --- 2013-02-06 Lee Jones New
[26/49] ARM: ux500: Partially revert changes surrounding audio regulators --- 2013-02-06 Lee Jones New
[25/49] regulator: ab8500-ext: Add support for AB8505/AB9540 --- 2013-02-06 Lee Jones Superseded
[24/49] regulator: ab8500: Correct TVOUT regulator start-up delay --- 2013-02-06 Lee Jones New
[23/49] regulator: ab8500: Add support for the ab9540 --- 2013-02-06 Lee Jones New
[22/49] regulator: ab8500: Prepare the driver for additional platforms --- 2013-02-06 Lee Jones Superseded
[21/49] regulator: ab8500: Clean out SoC registers --- 2013-02-06 Lee Jones Accepted
[20/49] ARM: ux500: regulators: List the MMIO camera as a consumer of VAUX1 --- 2013-02-06 Lee Jones Accepted
[19/49] ARM: ux500: Add supply for the Cypress TrueTouch Touchscreen --- 2013-02-06 Lee Jones Accepted
[18/49] ARM: ux500: Add supply for the Pressure sensor --- 2013-02-06 Lee Jones Accepted
[17/49] ARM: ux500: Add supply for the Ambient light sensor device --- 2013-02-06 Lee Jones Accepted
[16/49] ARM: ux500: Add supply for the Proximity and Hal sensor --- 2013-02-06 Lee Jones New
[15/49] ARM: ux500: Add supply for the L3G4200D Gyroscope --- 2013-02-06 Lee Jones Accepted
[14/49] regulator: ab8500: Init debug from regulator driver --- 2013-02-06 Lee Jones Superseded
[13/49] regulator: ab8500: Remove USB regulator --- 2013-02-06 Lee Jones New
[12/49] regulator: ab8500-ext: Add suspend support --- 2013-02-06 Lee Jones New
[11/49] regulator: ab8500-ext: Add HW request support --- 2013-02-06 Lee Jones New
[10/49] regulator: ab8500-ext: Cosmetic changes --- 2013-02-06 Lee Jones New
[09/49] ARM: ux500: Update displays in vaux1 consumer list --- 2013-02-06 Lee Jones Accepted
[08/49] regulator: ab8500: Add support of low voltage battery --- 2013-02-06 Lee Jones New
[07/49] regulator: ab8500: Separate regulator and MFD platform data --- 2013-02-06 Lee Jones Accepted
[06/49] regulator: ab8500: Another push to synchronise recent AB8500 developments --- 2013-02-06 Lee Jones Accepted
[05/49] ARM: ux500: regulators: Add mask for configuration --- 2013-02-06 Lee Jones Accepted
[04/49] regulator: ab8500: Added get_optimum_mode on regulators with idle mode --- 2013-02-06 Lee Jones Accepted
[03/49] regulator: ab8500: Fix for regulator_set_mode functionality --- 2013-02-06 Lee Jones New
[02/49] regulator: ab8500: Add set_mode/get_mode support --- 2013-02-06 Lee Jones New
[01/49] regulator: ab8500: Further populate initialisation registers --- 2013-02-06 Lee Jones Accepted
[73/73] ARM: ux500: Pass regulator platform data using the new format --- 2013-02-04 Lee Jones New
[72/73] regulator: ab8500: Use regulator_list_voltage_table() to look-up voltages --- 2013-02-04 Lee Jones Superseded
[71/73] regulator: ab8500: Remove the need for a 'delay' property --- 2013-02-04 Lee Jones New
[70/73] regulator: ab8500: Set enable enable_time in regulator_desc --- 2013-02-04 Lee Jones New
[69/73] regulator: ab8500: Introduce aux5, aux6 regulators for AB8540 --- 2013-02-04 Lee Jones New
[68/73] regulator: ab8500: Provide DT support for additional platforms --- 2013-02-04 Lee Jones New
[67/73] regulator: ab8500: Use a struct to select the good regulator configuration --- 2013-02-04 Lee Jones New
[66/73] regulator: ab8500-ext: Adapt regulator registration for newly changed API --- 2013-02-04 Lee Jones New
[65/73] regulator: ab8500: Update VAna supply management for the AB9540 --- 2013-02-04 Lee Jones New
[64/73] regulator: ab8500: Update vdmic, vamic[1|2] parameters for AB8540 --- 2013-02-04 Lee Jones New
[63/73] regulator: ab8500: Add mode operation for v-amic --- 2013-02-04 Lee Jones Superseded
[62/73] regulator: ab8500: Remove vusb from AB8540 regulator framework --- 2013-02-04 Lee Jones New
[61/73] regulator: ab8500: Default value on LDO USB to HP --- 2013-02-04 Lee Jones New
[60/73] ARM: ux500: regulators: Add LDO USB consumer --- 2013-02-04 Lee Jones New
[59/73] regulator: ab8500: Change mode fix for LDO USB --- 2013-02-04 Lee Jones New
[58/73] regulator: ab8500: Add new operations for Vaux3 --- 2013-02-04 Lee Jones New
[57/73] regulator: ab8500: Remove surplus include of id.h --- 2013-02-04 Lee Jones New
[56/73] regulator: ab8500: Also check for AB8505 based platforms --- 2013-02-04 Lee Jones New
[55/73] regulator: ab8500: Provide ExtSupply register init values for AB8505 --- 2013-02-04 Lee Jones New
[54/73] regulator: ab8500: Add voltage selection for AUDIO and ANA on AB8505 --- 2013-02-04 Lee Jones New
[53/73] regulator: ab8500: Don't register external regulators on AB8505 --- 2013-02-04 Lee Jones Superseded
[52/73] ARM ux500: Remove external regulators from AB8505 init data --- 2013-02-04 Lee Jones New
[51/73] regulator: ab8500: Regulator vaux8 not declared using correct name --- 2013-02-04 Lee Jones New
[50/73] regulator: ab8500: Correct regulator id values --- 2013-02-04 Lee Jones New
[49/73] regulator: ab8500: Fix vsdio parameters for AB8540 based platforms --- 2013-02-04 Lee Jones New
« 1 2 ... 4 5 6 7 »