@@ -74,7 +74,6 @@
#define ERR_IRQ_ALL (ERR_AER | ERR_AXI | ERR_CORR | \
ERR_NONFATAL | ERR_FATAL | ERR_SYS)
-#define MAX_MSI_HOST_IRQS 8
/* PCIE controller device IDs */
#define PCIE_RC_K2HK 0xb008
#define PCIE_RC_K2E 0xb009
@@ -89,7 +88,7 @@ struct keystone_pcie {
u32 device_id;
struct device_node *legacy_intc_np;
- int msi_host_irqs[MAX_MSI_HOST_IRQS];
+ int msi_host_irq;
int num_lanes;
u32 num_viewport;
struct phy **phy;
@@ -527,9 +526,9 @@ static int ks_pcie_establish_link(struct keystone_pcie *ks_pcie)
static void ks_pcie_msi_irq_handler(struct irq_desc *desc)
{
- unsigned int irq = irq_desc_get_irq(desc);
+ unsigned int irq = desc->irq_data.hwirq;
struct keystone_pcie *ks_pcie = irq_desc_get_handler_data(desc);
- u32 offset = irq - ks_pcie->msi_host_irqs[0];
+ u32 offset = irq - ks_pcie->msi_host_irq;
struct dw_pcie *pci = ks_pcie->pci;
struct device *dev = pci->dev;
struct irq_chip *chip = irq_desc_get_chip(desc);
@@ -587,6 +586,7 @@ static int ks_pcie_config_msi_irq(struct keystone_pcie *ks_pcie)
struct device *dev = ks_pcie->pci->dev;
struct device_node *np = ks_pcie->np;
struct device_node *intc_np;
+ struct irq_data *irq_data;
int irq_count;
int irq;
int ret;
@@ -608,19 +608,21 @@ static int ks_pcie_config_msi_irq(struct keystone_pcie *ks_pcie)
goto err;
}
- if (irq_count > MAX_MSI_HOST_IRQS) {
- dev_warn(dev, "Too many MSI interrupt lines defined %u\n",
- irq_count);
- irq_count = MAX_MSI_HOST_IRQS;
- }
-
for (i = 0; i < irq_count; i++) {
irq = irq_of_parse_and_map(intc_np, i);
if (!irq) {
ret = -EINVAL;
goto err;
}
- ks_pcie->msi_host_irqs[i] = irq;
+
+ if (!ks_pcie->msi_host_irq) {
+ irq_data = irq_get_irq_data(irq);
+ if (!irq_data) {
+ ret = -EINVAL;
+ goto err;
+ }
+ ks_pcie->msi_host_irq = irq_data->hwirq;
+ }
irq_set_chained_handler_and_data(irq, ks_pcie_msi_irq_handler,
ks_pcie);
ks_pcie_msi_irq_handler() uses 'virq' to get the IRQ number offset. This offset is used to get the correct MSI_IRQ_STATUS register corresponding to the IRQ line that raised the interrupt. There is no guarantee that 'virq' assigned for consecutive hardware IRQ will be contiguous. And this might get us an incorrect IRQ number offset. Fix it here by using 'hwirq' to get the IRQ number offset. Since we don't store the 'virq' numbers of all the IRQ numbers, stop checking if irq count is greater than MAX_MSI_HOST_IRQS and remove MAX_MSI_HOST_IRQS. Link: https://lkml.kernel.org/r/bb081d21-7c03-0357-4294-7e92d95d838c@arm.com Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com> --- drivers/pci/controller/dwc/pci-keystone.c | 24 ++++++++++++----------- 1 file changed, 13 insertions(+), 11 deletions(-) -- 2.17.1