diff mbox series

[5.15,089/207] net: dsa: mv88e6xxx: Fix inband AN for 2500base-x on 88E6393X family

Message ID 20211206145613.314182236@linuxfoundation.org
State New
Headers show
Series None | expand

Commit Message

Greg Kroah-Hartman Dec. 6, 2021, 2:55 p.m. UTC
From: Marek BehĂșn <kabel@kernel.org>

commit 163000dbc772c1eae9bdfe7c8fe30155db1efd74 upstream.

Inband AN is broken on Amethyst in 2500base-x mode when set by standard
mechanism (via cmode).

(There probably is some weird setting done by default in the switch for
 this mode that make it cycle in some state or something, because when
 the peer is the mvneta controller, it receives link change interrupts
 every ~0.3ms, but the link is always down.)

Get around this by configuring the PCS mode to 1000base-x (where inband
AN works), and then changing the SerDes frequency while SerDes
transmitter and receiver are disabled, before enabling SerDes PHY. After
disabling SerDes PHY, change the PCS mode back to 2500base-x, to avoid
confusing the device (if we leave it at 1000base-x PCS mode but with
different frequency, and then change cmode to sgmii, the device won't
change the frequency because it thinks it already has the correct one).

The register which changes the frequency is undocumented. I discovered
it by going through all registers in the ranges 4.f000-4.f100 and
1e.8000-1e.8200 for all SerDes cmodes (sgmii, 1000base-x, 2500base-x,
5gbase-r, 10gbase-r, usxgmii) and filtering out registers that didn't
make sense (the value was the same for modes which have different
frequency). The result of this was:

    reg   sgmii 1000base-x 2500base-x 5gbase-r 10gbase-r usxgmii
  04.f002  005b       0058       0059     005c      005d    005f
  04.f076  3000       0000       1000     4000      5000    7000
  04.f07c  0950       0950       1850     0550      0150    0150
  1e.8000  0059       0059       0058     0055      0051    0051
  1e.8140  0e20       0e20       0e28     0e21      0e42    0e42

Register 04.f002 is the documented Port Operational Confiuration
register, it's last 3 bits select PCS type, so changing this register
also changes the frequency to the appropriate value.

Registers 04.f076 and 04.f07c are not writable.

Undocumented register 1e.8000 was the one: changing bits 3:0 from 9 to 8
changed SerDes frequency to 3.125 GHz, while leaving the value of PCS
mode in register 04.f002.2:0 at 1000base-x. Inband autonegotiation
started working correctly.

(I didn't try anything with register 1e.8140 since 1e.8000 solved the
 problem.)

Since I don't have documentation for this register 1e.8000.3:0, I am
using the constants without names, but my hypothesis is that this
register selects PHY frequency. If in the future I have access to an
oscilloscope able to handle these frequencies, I will try to test this
hypothesis.

Fixes: de776d0d316f ("net: dsa: mv88e6xxx: add support for mv88e6393x family")
Signed-off-by: Marek BehĂșn <kabel@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
 drivers/net/dsa/mv88e6xxx/serdes.c |   61 ++++++++++++++++++++++++++++++++++++-
 drivers/net/dsa/mv88e6xxx/serdes.h |    1 
 2 files changed, 61 insertions(+), 1 deletion(-)
diff mbox series

Patch

--- a/drivers/net/dsa/mv88e6xxx/serdes.c
+++ b/drivers/net/dsa/mv88e6xxx/serdes.c
@@ -1419,6 +1419,54 @@  static int mv88e6393x_serdes_erratum_5_2
 	return 0;
 }
 
+static int mv88e6393x_serdes_fix_2500basex_an(struct mv88e6xxx_chip *chip,
+					      int lane, u8 cmode, bool on)
+{
+	u16 reg;
+	int err;
+
+	if (cmode != MV88E6XXX_PORT_STS_CMODE_2500BASEX)
+		return 0;
+
+	/* Inband AN is broken on Amethyst in 2500base-x mode when set by
+	 * standard mechanism (via cmode).
+	 * We can get around this by configuring the PCS mode to 1000base-x
+	 * and then writing value 0x58 to register 1e.8000. (This must be done
+	 * while SerDes receiver and transmitter are disabled, which is, when
+	 * this function is called.)
+	 * It seem that when we do this configuration to 2500base-x mode (by
+	 * changing PCS mode to 1000base-x and frequency to 3.125 GHz from
+	 * 1.25 GHz) and then configure to sgmii or 1000base-x, the device
+	 * thinks that it already has SerDes at 1.25 GHz and does not change
+	 * the 1e.8000 register, leaving SerDes at 3.125 GHz.
+	 * To avoid this, change PCS mode back to 2500base-x when disabling
+	 * SerDes from 2500base-x mode.
+	 */
+	err = mv88e6390_serdes_read(chip, lane, MDIO_MMD_PHYXS,
+				    MV88E6393X_SERDES_POC, &reg);
+	if (err)
+		return err;
+
+	reg &= ~(MV88E6393X_SERDES_POC_PCS_MASK | MV88E6393X_SERDES_POC_AN);
+	if (on)
+		reg |= MV88E6393X_SERDES_POC_PCS_1000BASEX |
+		       MV88E6393X_SERDES_POC_AN;
+	else
+		reg |= MV88E6393X_SERDES_POC_PCS_2500BASEX;
+	reg |= MV88E6393X_SERDES_POC_RESET;
+
+	err = mv88e6390_serdes_write(chip, lane, MDIO_MMD_PHYXS,
+				     MV88E6393X_SERDES_POC, reg);
+	if (err)
+		return err;
+
+	err = mv88e6390_serdes_write(chip, lane, MDIO_MMD_VEND1, 0x8000, 0x58);
+	if (err)
+		return err;
+
+	return 0;
+}
+
 int mv88e6393x_serdes_power(struct mv88e6xxx_chip *chip, int port, int lane,
 			    bool on)
 {
@@ -1437,6 +1485,11 @@  int mv88e6393x_serdes_power(struct mv88e
 		if (err)
 			return err;
 
+		err = mv88e6393x_serdes_fix_2500basex_an(chip, lane, cmode,
+							 true);
+		if (err)
+			return err;
+
 		err = mv88e6393x_serdes_power_lane(chip, lane, true);
 		if (err)
 			return err;
@@ -1457,8 +1510,14 @@  int mv88e6393x_serdes_power(struct mv88e
 	if (err)
 		return err;
 
-	if (!on)
+	if (!on) {
 		err = mv88e6393x_serdes_power_lane(chip, lane, false);
+		if (err)
+			return err;
+
+		err = mv88e6393x_serdes_fix_2500basex_an(chip, lane, cmode,
+							 false);
+	}
 
 	return err;
 }
--- a/drivers/net/dsa/mv88e6xxx/serdes.h
+++ b/drivers/net/dsa/mv88e6xxx/serdes.h
@@ -93,6 +93,7 @@ 
 #define MV88E6393X_SERDES_POC_PCS_MASK		0x0007
 #define MV88E6393X_SERDES_POC_RESET		BIT(15)
 #define MV88E6393X_SERDES_POC_PDOWN		BIT(5)
+#define MV88E6393X_SERDES_POC_AN		BIT(3)
 #define MV88E6393X_SERDES_CTRL1			0xf003
 #define MV88E6393X_SERDES_CTRL1_TX_PDOWN	BIT(9)
 #define MV88E6393X_SERDES_CTRL1_RX_PDOWN	BIT(8)