@@ -62,8 +62,10 @@ int dram_init(void)
phys_addr_t board_get_usable_ram_top(phys_size_t total_size)
{
+ int ret;
phys_size_t size;
phys_addr_t reg;
+ u32 optee_start, optee_size;
if (!total_size)
return gd->ram_top;
@@ -73,16 +75,10 @@ phys_addr_t board_get_usable_ram_top(phys_size_t total_size)
* if the effective available memory is bigger
*/
gd->ram_top = clamp_val(gd->ram_top, 0, SZ_4G - 1);
+ size = ALIGN(SZ_8M + CONFIG_SYS_MALLOC_LEN + total_size, MMU_SECTION_SIZE);
- /* found enough not-reserved memory to relocated U-Boot */
- lmb_add(gd->ram_base, gd->ram_top - gd->ram_base);
- boot_fdt_add_mem_rsv_regions((void *)gd->fdt_blob);
- /* add 8M for reserved memory for display, fdt, gd,... */
- size = ALIGN(SZ_8M + CONFIG_SYS_MALLOC_LEN + total_size, MMU_SECTION_SIZE),
- reg = lmb_alloc(size, MMU_SECTION_SIZE);
-
- if (!reg)
- reg = gd->ram_top - size;
+ ret = optee_get_reserved_memory(&optee_start, &optee_size);
+ reg = (!ret ? optee_start : gd->ram_top) - size;
/* before relocation, mark the U-Boot memory as cacheable by default */
if (!(gd->flags & GD_FLG_RELOC))
The value of ram_top address currently gets computed in an indirect manner. The boot_fdt_add_mem_rsv_regions() function gets called first to reserve the memory region occupied by OP-TEE in the LMB memory map. This is followed by a call to the lmb_alloc() API, which returns an address which is below the OP-TEE base address. This address is the value of ram_top returned by the board_get_usable_ram_top() function. This has now changed, as the LMB memory map, which is no longer local, gets set up after relocation. Get the OP-TEE base address by reading the device tree, and set the ram_top from this value. Signed-off-by: Sughosh Ganu <sughosh.ganu@linaro.org> --- Changes since V2: None arch/arm/mach-stm32mp/dram_init.c | 14 +++++--------- 1 file changed, 5 insertions(+), 9 deletions(-)