diff mbox series

[1/4] dt-bindings: connector: Add typec orientation switch properties

Message ID 20220822153517.3747679-2-xu.yang_2@nxp.com
State Superseded
Headers show
Series typec orientation switch support via mux controller | expand

Commit Message

Xu Yang Aug. 22, 2022, 3:35 p.m. UTC
Typec orientation switch can be implemented as a consumer of mux
controller. So we can use mux controller to control simple gpio switch
or other types of switch. This will cover the following typec switch
use case: High Speed, Super Speed and Sideband switch.

Signed-off-by: Xu Yang <xu.yang_2@nxp.com>
---
 .../bindings/connector/usb-connector.yaml      | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/connector/usb-connector.yaml b/Documentation/devicetree/bindings/connector/usb-connector.yaml
index ae515651fc6b..47f53cdbf31a 100644
--- a/Documentation/devicetree/bindings/connector/usb-connector.yaml
+++ b/Documentation/devicetree/bindings/connector/usb-connector.yaml
@@ -221,6 +221,24 @@  properties:
       SNK_READY for non-pd link.
     type: boolean
 
+  # The following are optional properties for "usb-c-connector".
+  mux-controls:
+    description: Mux controller node to use for orientation switch selection. This mux controller
+      could handle High Speed, Super Speed and Sideband switch use case one time. In orde to do so,
+      besides mux settings need to be properly configured for each switch under mux-controller node,
+      correct states should also be assigned to typec-switch-states parameter.
+    maxItems: 1
+
+  typec-switch-states:
+    description: An ordered u32 array describing the mux state value for each typec orientations.
+      Three states correspond to NONE(high impedance), NORMAL, REVERSE respectively. If there is
+      no HW mux state for NONE, use value of NORMAL or REVERSE for it. If this mux controller
+      handle more than 1 switch, correct states value need to be caculated according to the mux
+      settings.
+    minItems: 3
+    maxItems: 3
+    $ref: /schemas/types.yaml#/definitions/uint32-array
+
 dependencies:
   sink-vdos-v1: [ 'sink-vdos' ]
   sink-vdos: [ 'sink-vdos-v1' ]