diff mbox series

[v8,2/4] usb: misc: eud: Add driver support for SM6115 / SM4250

Message ID 20230717103236.1246771-3-bhupesh.sharma@linaro.org
State New
Headers show
Series Add Qualcomm SM6115 / SM4250 EUD dt-bindings & driver support | expand

Commit Message

Bhupesh Sharma July 17, 2023, 10:32 a.m. UTC
Add SM6115 / SM4250 SoC EUD support in qcom_eud driver.

On some SoCs (like the SM6115 / SM4250 SoC), the mode manager
needs to be accessed only via the secure world (through 'scm'
calls).

Also, the enable bit inside 'tcsr_check_reg' needs to be set
first to set the eud in 'enable' mode on these SoCs.

Signed-off-by: Bhupesh Sharma <bhupesh.sharma@linaro.org>
---
 drivers/usb/misc/Kconfig    |  2 +-
 drivers/usb/misc/qcom_eud.c | 62 ++++++++++++++++++++++++++++++++++---
 2 files changed, 58 insertions(+), 6 deletions(-)
diff mbox series

Patch

diff --git a/drivers/usb/misc/Kconfig b/drivers/usb/misc/Kconfig
index 99b15b77dfd57..51eb5140caa14 100644
--- a/drivers/usb/misc/Kconfig
+++ b/drivers/usb/misc/Kconfig
@@ -146,7 +146,7 @@  config USB_APPLEDISPLAY
 
 config USB_QCOM_EUD
 	tristate "QCOM Embedded USB Debugger(EUD) Driver"
-	depends on ARCH_QCOM || COMPILE_TEST
+	depends on (ARCH_QCOM && QCOM_SCM) || COMPILE_TEST
 	select USB_ROLE_SWITCH
 	help
 	  This module enables support for Qualcomm Technologies, Inc.
diff --git a/drivers/usb/misc/qcom_eud.c b/drivers/usb/misc/qcom_eud.c
index 7f371ea1248c3..136cac90228a0 100644
--- a/drivers/usb/misc/qcom_eud.c
+++ b/drivers/usb/misc/qcom_eud.c
@@ -11,9 +11,11 @@ 
 #include <linux/kernel.h>
 #include <linux/module.h>
 #include <linux/of.h>
+#include <linux/of_device.h>
 #include <linux/platform_device.h>
 #include <linux/slab.h>
 #include <linux/sysfs.h>
+#include <linux/firmware/qcom/qcom_scm.h>
 #include <linux/usb/role.h>
 
 #define EUD_REG_INT1_EN_MASK	0x0024
@@ -30,15 +32,25 @@ 
 #define EUD_INT_SAFE_MODE	BIT(4)
 #define EUD_INT_ALL		(EUD_INT_VBUS | EUD_INT_SAFE_MODE)
 
+#define EUD_EN2_EN		BIT(0)
+#define EUD_EN2_DISABLE		(0)
+#define TCSR_CHECK_EN		BIT(0)
+
+struct eud_soc_cfg {
+	u32 tcsr_check_offset;
+};
+
 struct eud_chip {
 	struct device			*dev;
 	struct usb_role_switch		*role_sw;
+	const struct eud_soc_cfg	*eud_cfg;
 	void __iomem			*base;
 	void __iomem			*mode_mgr;
 	unsigned int			int_status;
 	int				irq;
 	bool				enabled;
 	bool				usb_attached;
+	phys_addr_t			secure_mode_mgr;
 };
 
 static int enable_eud(struct eud_chip *priv)
@@ -46,7 +58,11 @@  static int enable_eud(struct eud_chip *priv)
 	writel(EUD_ENABLE, priv->base + EUD_REG_CSR_EUD_EN);
 	writel(EUD_INT_VBUS | EUD_INT_SAFE_MODE,
 			priv->base + EUD_REG_INT1_EN_MASK);
-	writel(1, priv->mode_mgr + EUD_REG_EUD_EN2);
+
+	if (priv->secure_mode_mgr)
+		qcom_scm_io_writel(priv->secure_mode_mgr + EUD_REG_EUD_EN2, EUD_EN2_EN);
+	else
+		writel(EUD_EN2_EN, priv->mode_mgr + EUD_REG_EUD_EN2);
 
 	return usb_role_switch_set_role(priv->role_sw, USB_ROLE_DEVICE);
 }
@@ -54,7 +70,11 @@  static int enable_eud(struct eud_chip *priv)
 static void disable_eud(struct eud_chip *priv)
 {
 	writel(0, priv->base + EUD_REG_CSR_EUD_EN);
-	writel(0, priv->mode_mgr + EUD_REG_EUD_EN2);
+
+	if (priv->secure_mode_mgr)
+		qcom_scm_io_writel(priv->secure_mode_mgr + EUD_REG_EUD_EN2, EUD_EN2_DISABLE);
+	else
+		writel(EUD_EN2_DISABLE, priv->mode_mgr + EUD_REG_EUD_EN2);
 }
 
 static ssize_t enable_show(struct device *dev,
@@ -178,6 +198,8 @@  static void eud_role_switch_release(void *data)
 static int eud_probe(struct platform_device *pdev)
 {
 	struct eud_chip *chip;
+	struct resource *res;
+	phys_addr_t tcsr_check;
 	int ret;
 
 	chip = devm_kzalloc(&pdev->dev, sizeof(*chip), GFP_KERNEL);
@@ -200,9 +222,34 @@  static int eud_probe(struct platform_device *pdev)
 	if (IS_ERR(chip->base))
 		return PTR_ERR(chip->base);
 
-	chip->mode_mgr = devm_platform_ioremap_resource(pdev, 1);
-	if (IS_ERR(chip->mode_mgr))
-		return PTR_ERR(chip->mode_mgr);
+	/*
+	 * EUD block on a few Qualcomm SoCs needs secure register access.
+	 * Check for the same via SoC specific config data.
+	 */
+	chip->eud_cfg = of_device_get_match_data(&pdev->dev);
+	if (chip->eud_cfg) {
+		res = platform_get_resource(pdev, IORESOURCE_MEM, 1);
+		if (!res)
+			return dev_err_probe(chip->dev, -ENODEV,
+					     "failed to get secure_mode_mgr reg base\n");
+
+		chip->secure_mode_mgr = res->start;
+
+		res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "tcsr-base");
+		if (!res)
+			return dev_err_probe(chip->dev, -ENODEV,
+					     "failed to get tcsr reg base\n");
+
+		tcsr_check = res->start + chip->eud_cfg->tcsr_check_offset;
+
+		ret = qcom_scm_io_writel(tcsr_check, TCSR_CHECK_EN);
+		if (ret)
+			return dev_err_probe(chip->dev, ret, "failed to write tcsr check reg\n");
+	} else {
+		chip->mode_mgr = devm_platform_ioremap_resource(pdev, 1);
+		if (IS_ERR(chip->mode_mgr))
+			return PTR_ERR(chip->mode_mgr);
+	}
 
 	chip->irq = platform_get_irq(pdev, 0);
 	ret = devm_request_threaded_irq(&pdev->dev, chip->irq, handle_eud_irq,
@@ -228,8 +275,13 @@  static void eud_remove(struct platform_device *pdev)
 	disable_irq_wake(chip->irq);
 }
 
+static const struct eud_soc_cfg sm6115_eud_cfg = {
+	.tcsr_check_offset = 0x25018,
+};
+
 static const struct of_device_id eud_dt_match[] = {
 	{ .compatible = "qcom,sc7280-eud" },
+	{ .compatible = "qcom,sm6115-eud", .data = &sm6115_eud_cfg },
 	{ }
 };
 MODULE_DEVICE_TABLE(of, eud_dt_match);