@@ -373,13 +373,9 @@ &mcu_i2c0 {
clock-frequency = <400000>;
};
-&main_sdhci0 {
- /* Unused */
- status = "disabled";
-};
-
&main_sdhci1 {
/* SD card */
+ status = "okay";
pinctrl-0 = <&main_mmc1_pins_default>;
pinctrl-names = "default";
disable-wp;
@@ -333,6 +333,7 @@ exp2: gpio@22 {
&main_sdhci0 {
/* eMMC */
+ status = "okay";
non-removable;
ti,driver-strength-ohm = <50>;
disable-wp;
@@ -340,6 +341,7 @@ &main_sdhci0 {
&main_sdhci1 {
/* SD card */
+ status = "okay";
pinctrl-0 = <&main_mmc1_pins_default>;
pinctrl-names = "default";
disable-wp;
@@ -665,6 +665,7 @@ main_sdhci0: mmc@4f80000 {
mmc-hs200-1_8v;
mmc-hs400-1_8v;
dma-coherent;
+ status = "disabled";
};
main_sdhci1: mmc@4fb0000 {
@@ -694,6 +695,7 @@ main_sdhci1: mmc@4fb0000 {
dma-coherent;
/* Masking support for SDR104 capability */
sdhci-caps-mask = <0x00000003 0x00000000>;
+ status = "disabled";
};
main_navss: bus@30000000 {
SDHCI nodes defined in the top-level J721s2 SoC dtsi files are incomplete and will not be functional unless they are extended. As the attached SD/eMMC is only known about at the board integration level, these nodes should only be enabled when provided with this information. Disable the SDHCI nodes in the dtsi files and only enable the ones that are actually pinned out on a given board. Signed-off-by: Andrew Davis <afd@ti.com> --- arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts | 6 +----- arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts | 2 ++ arch/arm64/boot/dts/ti/k3-j721s2-main.dtsi | 2 ++ 3 files changed, 5 insertions(+), 5 deletions(-)