@@ -625,7 +625,6 @@ ts_int_default: ts-int-default-state {
function = "gpio";
drive-strength = <2>;
bias-disable;
- input-enable;
};
ap2mdm_default: ap2mdm-default-state {
@@ -2436,7 +2436,6 @@ clk-pins {
pins = "gpio10";
function = "wsa_swr_clk";
drive-strength = <2>;
- input-enable;
bias-pull-down;
};
@@ -2444,7 +2443,6 @@ data-pins {
pins = "gpio11";
function = "wsa_swr_data";
drive-strength = <2>;
- input-enable;
bias-pull-down;
};
};
@@ -2460,7 +2458,6 @@ data-pins {
pins = "gpio7";
function = "dmic1_data";
drive-strength = <8>;
- input-enable;
};
};
@@ -2478,7 +2475,6 @@ data-pins {
function = "dmic1_data";
drive-strength = <2>;
bias-pull-down;
- input-enable;
};
};
@@ -2523,7 +2519,6 @@ clk-pins {
pins = "gpio0";
function = "swr_tx_clk";
drive-strength = <2>;
- input-enable;
bias-pull-down;
};
@@ -2531,7 +2526,6 @@ data1-pins {
pins = "gpio1";
function = "swr_tx_data";
drive-strength = <2>;
- input-enable;
bias-bus-hold;
};
@@ -2539,7 +2533,6 @@ data2-pins {
pins = "gpio2";
function = "swr_tx_data";
drive-strength = <2>;
- input-enable;
bias-pull-down;
};
};
Pin configuration property "input-enable" was used with the intention to disable the output, but this is done by default by Linux drivers. Since patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not input-enable") the property is not accepted anymore. Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> --- arch/arm64/boot/dts/qcom/sm8250-sony-xperia-edo.dtsi | 1 - arch/arm64/boot/dts/qcom/sm8250.dtsi | 7 ------- 2 files changed, 8 deletions(-)